When configuring the Original Spanning-Tree Protocol (802.1D) on Layer 2 Cisco Switches, you must enable features such as PortFast, UplinkFast, and BackboneFast to improve STP Convergence performance.
Tag: Spanning Tree
How to Use Root Primary Command in Spanning Tree in GNS3
When we configure the Spanning Tree Protocol on Cisco Switches, we usually use the spanning-tree vlan priority command when selecting Root Bridge Switch.
How to Select Root Bridge using Root Primary Command in Cisco Packet Tracer
Selecting the main bridge in a network is a big job because it decides how things talk to each other in the network. Cisco Packet Tracer is a vital tool that helps network engineers practice different network situations.
In this article, we will talk about how to choose the main bridge using the “Root Primary” command in Packet Tracer. This command is an easy but good way to figure out which bridge is the main one in a network. So, let’s look closely at this topic and understand it better.
What is RSTP (Rapid Spanning Tree Protocol – 802.1W)? | Definition and Features
RSTP (Rapid Spanning Tree Protocol) is like an intelligent helper for the network. It stops loops and works faster than the older STP. This protocol makes sure devices adjust quickly to changes in the LAN. It keeps things running well, making sure everything is available and works smoothly. That’s why many experts like using it. In this article, we’ll check out what RSTP is, its excellent features, and how it works in networking.
The Standard Spanning Tree Protocol prevents network loops on Cisco Switches (802.1D). If there’s a link or cable problem, it figures out the best route for the packet to reach its destination.
Spanning Tree Show Commands | A Guide for Network Professionals
In a network, the spanning tree protocol (STP) is super important. It stops loops, which can mess up things like broadcast storms. It uses clever math to create a loop-free setup for Ethernet networks. To keep an eye on it, network admins use different show commands. In this article, we’ll check out some common show commands that tell us about the STP protocol setup and how it’s doing.
After configuring the Spanning Tree Protocol, which is usually configured on Layer 2 Switches, it may be necessary to verify the settings made. When configuring Cisco Switches, we typically use the CLI command prompt.
How to Configure BackboneFast on Cisco Switch in GNS3
When configuring the Standard Spanning Tree Protocol, we often come across terms such as UplinkFast, PortFast, and BackboneFast. These features are specific to the Cisco brand only, and they cannot use with other brands.