Tag: Spanning Tree

The Spanning Tree Protocol (STP) in computer networking stops loops in the network setup. It’s vital for keeping the network stable and preventing broadcast storms. It works by specifying a single “root” bridge and then turning off connections that might cause loops. So, STP is a protocol we commonly use. However, it can be a little tricky to configure.

In this article, we’ll show you how to configure the Spanning Tree Protocol on a Layer 2 Switch. We’ll use GNS3, a network simulation tool, to do it. We’ll look at essential features like PortFast, BPDU guard, and root guard. After that, we’ll show you how to set it up to work with VPCS computers.

Continue Reading…

When we configure the Spanning Tree Protocol on Cisco Switches, we usually use the spanning-tree vlan priority command when selecting Root Bridge Switch.

Continue Reading…

Selecting the main bridge in a network is a big job because it decides how things talk to each other in the network. Cisco Packet Tracer is a vital tool that helps network engineers practice different network situations.

In this article, we will talk about how to choose the main bridge using the “Root Primary” command in Packet Tracer. This command is an easy but good way to figure out which bridge is the main one in a network. So, let’s look closely at this topic and understand it better.

Continue Reading…

RSTP (Rapid Spanning Tree Protocol) is like an intelligent helper for the network. It stops loops and works faster than the older STP. This protocol makes sure devices adjust quickly to changes in the LAN. It keeps things running well, making sure everything is available and works smoothly. That’s why many experts like using it. In this article, we’ll check out what RSTP is, its excellent features, and how it works in networking.

The Standard Spanning Tree Protocol prevents network loops on Cisco Switches (802.1D). If there’s a link or cable problem, it figures out the best route for the packet to reach its destination.

Continue Reading…

In a network, the spanning tree protocol (STP) is super important. It stops loops, which can mess up things like broadcast storms. It uses clever math to create a loop-free setup for Ethernet networks. To keep an eye on it, network admins use different show commands. In this article, we’ll check out some common show commands that tell us about the STP protocol setup and how it’s doing.

After configuring the Spanning Tree Protocol, which is usually configured on Layer 2 Switches, it may be necessary to verify the settings made. When configuring Cisco Switches, we typically use the CLI command prompt.

Continue Reading…

When configuring the Standard Spanning Tree Protocol, we often come across terms such as UplinkFast, PortFast, and BackboneFast. These features are specific to the Cisco brand only, and they cannot use with other brands.

Continue Reading…