What is Static Route in Router? – Static Route is a fixed, manually configured routing route implemented on Routers.
What is Static Route in Router?

What is Static Route in Router?

What is Static Route in Router?

Static Routes are used to determine where to send an IP packet to a router on the network. Each interface on the Cisco Routers represents an IP network.

The interfaces on the Cisco Router write their own network address in their own routing table. Therefore, according to the entries in the Router routing table, it can decide where the IP packet will go.

A network administrator can manually configure IP packets going to a specific network using the Static Routes. Static Routes are not deleted from the Router routing table unless they are removed by the administrator.

Static Routes are named with the letter S in the Cisco Router routing table.

When the Static Route is requested to be removed, the network administrator has to do the manual action. The route is not deleted from the routing table like the Dynamic Route protocol.

Three factors are considered when configuring a Static Route.

1. Destination Address to which IP Package will go.
2. Subnet Mask of the IP Package.
3. Which interface or IP address will the IP packet go through?

Our Recommendation

You can purchase “Cisco Networking All-in-One For Dummies” from Amazon.

What is the Command for Static Route in Cisco Router?

The use of the IP route command is a simple one-line operation. You can easily configure Static Route on Cisco Routers in privileged configuration mode.

This command;

[code] R1(config)# ip route 192.168.10.0 255.255.255.0 10.1.1.2
[/code]

If we explain the above command, IP packets can reach the 192.168.10.0 255.255.255.0 network via 10.1.1.2.

Another example for using ip route command;

[code] R1(config)# ip route 192.168.10.0 255.255.255.0 FastEthernet0/0
[/code]

The above IP route is a different configuration of the use of the command. At the end of the command, there is FastEthernet0/0 interface. This interface is the interface of the Cisco Router that is configured to Static Route. In short, it is not the interface of the opposite router.

What is Static Route in Router? ⇒ Video

You can watch what is the command for Static Route in Cisco Router and also subscribe to our YouTube channel…

  Final Word

What is Static Route in Router? – After giving brief information about the static routes, we showed two different ways to use the IP route command.

If this article is helpful, send me feedback by commenting! Thanks in advance, take care of yourself!

Also, you can add to browser bookmarks by pressing the CTRL+D to read this article later!

Articles Related to What is Static Route in Router

Products Related to What is Static Route in Router
Related Products

Leave a Reply

Your email address will not be published. Required fields are marked *

eleven − 7 =